Node-RED support for sending and receiving with [RaspyRFM] radio module

Nodes

$3

alt="RC pulse properties"
style="float: left; margin-right: 250px;" />
Node for sending & receiving RC pulse devices. Control RC sockets and receive buttons and sensors. Supports Intertechno, Logilight, Brennenstuhl, Emylo, Nexa, Telldus & many others
All settings are configurable in node's properties. The settings can optionally be overridden using msg.payload as an object.

$3

Node for receiving wireless temperature-/humiditysensors

Installation

npm install node-red-contrib-raspyrfm

Supported devices

* Intertechno (old tristate and newer 32 bit) sockets & remote controls
* Hama sockets & remote controls
* Brennenstuhl RCS1000 sockets & remote controls
* Logilight sockets & remote controls
* Pilota casa sockets & remote controls
* Emylo sockets & remote controls
* ELV FS20 sockets & remote controls
* Voltcraft RC30 sockets & remote controls
* REV Ritter SA-MC08-N04-D magnetic switch
* Nexa sockets, PIR sensors, contacts
* Telldus sockets, contacts, PIR sensors

Operation

On a raspberry PI, connect the [RaspyRFM] radio module, follow the installation instructions and run:
./rcpulsegw.py
In Node-RED draw RC pulse node on your flow and configure.

Example:
* RC Pulse node "MuFu" controls 4 RC sockets trigger by UI buttons
* Big Timer controlling RC pulse node "Licht Flur", switching on lights at dusk, off at dawn
* RC Pulse node "RC Pulse" sending a message to Telegram when a button on the RC remote is pressed
* RC Pulse node "Emylo A" switching on a WLED device for 10 minutes after button is pressed

!Flow Example

[RaspyRFM]:http://www.seegel-systeme.de/2015/09/02/ein-funkmodul-fuer-den-raspberry-raspyrfm/